Measuring Range:the botton of the jar lightwave arrived. If a irregular jar with sunken ,then it can not be measured
when measuring the low dielectric constant medium, if its level is lower than the liquid level measurement and the bottom of the tank is visible, and To make sure the accuracy of measured value, you can adjust the zero point upwards to the bottom of the tank position. Although the measurement range value can reach the tip position of the antenna tip, this is only an ideal state. In reality, the adhesion effect needs to be considered, so the measurement value should be fixed at least 100mm from the top of the antenna.
If the measured medium is in constant motion, in order to ensure the accuracy of the measurement, it is recommended to fix the waveguide on the middle and bottom of the piggy bank. During the welding process, it is necessary to ensure the smoothness of the inner wall of the waveguide. In order to prevent the influence of the unevenness on the guided wave, it is necessary to ensure the smoothness of the welding.